CARP ACADEMY Pulsar electronic bite alarm 2+1 Electronic bite alarm

Name: CARP ACADEMY Pulsar electronic bite alarm 2+1 Electronic bite alarm
Brand: Carp Academy
SKU: 6315-002
Price: 94.71 EUR
Availability: InStock

Quality Gear for

Your Guaranteed Catch

More Than a Shop:

For Anglers, By Anglers

Gear You Can Trust

for the Moment That Matters

Everything for the Water

, All in One Place

94.71 €

Unit price: 94.71 €/pcs

In supplier's stock
We will source this item within 4 - 6 business days and ship it to you immediately!

Buy with registration and 0.95 € points earn after you collect your delivery!

Item number:

6315-002

Brand:

Carp Academy

Three-button electronic bite alarm.

With built-in battery charge indicator, 20 sec bite after-signal, 150-300m range.
The set is delivered with a plastic carrying bag.

1. On/Off: Insert the 9V batteries into the transmitter units, observing polarity. You can check its readiness for use by sliding the on/off button at the bottom of the alarm. Insert the battery into the receiver as well, then you can adjust its operation with the on/off button on top of the unit. /When switching off, the LEDs will remain lit for a few seconds./

2. V button / Volume adjustment: By turning the V button, you can set 4 volume levels. The sound intensifies clockwise.

3. T button / Tone adjustment: By turning the T button, you can set 4 tone colors. The sound becomes higher clockwise.

4. S button / Sensitivity adjustment: By turning the S button, you can set 4 sensitivity levels. It intensifies counter-clockwise.

5. Programming: The receiver is factory programmed to the transmitters.

6. Range: 150-300 m - depending on terrain obstacles

7. Bite indication: The LED of the alarm on the rod where the bite occurs will light up. Simultaneously, the LED of the corresponding color will also light up on the receiver. /Bite after-signal 20sec./

Battery Charge Indicator: If the LED of any transmitter flashes repeatedly, it indicates a low battery level.

Reprogramming: If you want to reprogram the transmitters and receivers to a different frequency band, you must do the following. All bite alarms must be in the off state. Then switch on the receiver, then press the program clear button located above the battery compartment on the back. The green LED on the receiver unit should then flash. Then the green LED bite alarm must be switched on.
The green LED on the receiver will start to light up, which means that the synchronization was successful. After this, the LED will turn off, and the tuned alarm must be switched off immediately. The program clear button must be pressed again, and the next LED /yellow/ will light up, to which the yellow LED alarm must be switched on in the same way.
The same must be done with all alarms one by one, but care must be taken that only one alarm can be switched on during reprogramming!
The tuning of each alarm must take place within 17 seconds, otherwise the radio signal will cease and the program clear button must be pressed again.

Maintenance: Always remove the batteries after use and store the set without batteries. The set is waterproof. However, if water gets into the internal electronics and the bite alarm starts to light up or beep continuously, remove the batteries and let the alarms dry with the back cover open.